Fusible and non-fusible pullout and molded case switch designs
high strength protective shield
UL listed
1 Inch knockouts on the bottom, back and side of unit
ample wiring space for mounting with a stud gun (single keyhole, two- or three-point mounting)
Padlockable door provision for safety and reduction of tampering
Metallic enclosures are bottom entry and exit only
Factory installed tamper resistant/weather-resistant receptacles are available as an option on some products
Detailed Description: Eaton/Cutler Hammer air conditioning disconnect is a disconnect located between a load center and air conditioner. Non-fused pullout and molded case switch devices provide personnel with a visible on-off disconnecting means. While fused pullout units also perform this function, they also provide an additional level of protection for the air conditioner.
Application | Elec Assemblies, Panels & EOEM - Electrical Assemblies, Panels and EOEMs |
Brand | Eaton |
Catalog Description | Eaton air conditioning disconnect, Fused pullout, 60A, 120/240V, 10 kAIC, #14-3 Cu/Al 60¦C or 75¦C, NEMA 3R Galvanized Steel enclosure, 3 hp at 120V, 10 hp at 240V, ANSI 61 gray |
Finish 2 | Gray |
GTIN |
00782114166932 |
Height | 8.7000 |
Height Unit | IN |
Item Status | A |
Length | 5.4000 |
Length UOM | IN |
Material | Galvanized Steel |
Mfr. # | DPF222R |
Standard | CSA Certified,UL Listed |
Type | Air conditioning disconnect |
UNSPSC | 39121309 |
Width | 3.1500 |
Width UOM | IN |